Allergies Health Article

Diagnosis

Allergies can often be diagnosed by a careful medical history, matching the onset of symptoms to the exposure to possible allergens. Allergy is suspected if the symptoms presented are characteristic of an allergic reaction and this occurs repeatedly upon exposure to the suspected allergan. Allergy tests can be used to identify potential allergens, but these must be supported by eveidence of allergic responses in the patient's clinical history.

Skin tests

Skin tests are performed by administering a tiny dose of the suspected allergen by pricking, scratching, puncturing or injecting the skin. The allergen is applied to the skin as an auqeous extract, usually on the back, forearms, or top of the thighs. Once in the skin, the allergen may produce a classic immune wheal and flare response (a skin lesion with a raise, white, compressible area surrounded by a red flare). The tests usually begin with prick tests or patch tests that expose the skin to small amounts of allergen to observe the response. A positive reaction will occur on the skin even if the allergen is at levels normally encountered in food or in the airways. Reactions are usually evaluated approximately fifteen minutes after exposure. Intradermal skin tests involved injection of the allergan into the dermis of the skin. These tests are more sensitive and are used for allergies associated with risk of death, such as allergies to antibiotics.

Allergen-Specific IgE Measurement

Tests that measure allergen-specific IgE antibodies generally follow a basic method. The allergen is bound to a solid support, either in the form of a cellulose sponge, microtiter plate, or paper disk. The patient's serum is prepared from a blood sample and is incubated with the solid phase. If allergen specific IgE antibodies are present, they will bind to the solid phase and be retained there when the rest of the serum is washed away. Next, an labeled antibody against the IgE is added and will bind to any IgE on the solid phase. The excess is washed away and the levels of IgE are determined. The commonly used RAST test (radio allergo sorbent test) employed radio-labeled Anti-IgE antibodies. Updated methods now incorporate the use of enyzmelabeled antibodies in ELISA assays (enzyme-linked immunosorbent assays).

Total Serum IgE

The total level of IgE in the serum is commonly measured with a two-site immunometric assay. Some research indicates that there is a higher level of total serum IgE in allergic as compared to non-allergic people. However, this may not always be the case as there is considerable overlap between the two groups. This test is useful for the diagnosis of allergic fungal sinusitis and bronchopulmonary aspergillosis. Other conditions that are not allergic in nature may give rise to higher IgE levels such as smoking, AIDS, infection with parasites, and IgE myeloma.

Provocation tests

These tests involve the administration of allergen to ellicit an immune response. Provocation tests, most commonly done with airborne allergens, present the allergen directly through the route normally involved. Delayed allergic contact dermatitis diagnosis involves similar methods by application of a skin patch with allergen to induce an allergic skin reaction. Food allergen provocation tests require abstinence from the suspect allergen for two weeks or more, followed by ingestion of a measured amount of the test substance administered as an opaque capsule along with a placebo control. Provocation tests are not used if anaphylaxis is is a concern due to the patient's medical history.

Future diagnostic methods

As of 2000, attempts have been made for direct measurement of immune mediators such as histamine, eosinophil cationic protein (ECP), and mast cell tryptase. Another, somewhat controversial, test is electrodermal testing or electro-acupuncture allergy testing. This test has been used in Europe and is under investigation in the United States, though not approved by the Food and Drug Administration. An electric potential is applied to the skin, the allergen presented, and the electrical resistance observed for changes. This method has not been verified.